I hate this scale, it says low battery and shuts off after just 3 months of sitting in the drawer. It infuriates me that there’s still a lot of energy in the battery, I can use that in remote controls with no issues
If there’s enough battery to say “low battery”, then there’s enough battery to show the measurements!
All of which is fixed by a voltage regulator
Except the cheap part. But likely not by much.
You can order 3000 3.3V low drop out (LDO) voltage regulators on LCSC for $25.50. That’s less than a penny each.
Yeah, but it’s more than 0 pennies each.
Doesn’t help when you need 3.3V and the batteries are now down to 2.5V they are not putting a boost converter in there.
Right. If your design requires 3.3V minimum then putting in a 3.3V battery and no boost converter is just dumb (or extremely user-hostile).
Batteries have one advantage over over supplies: extremely low noise. Even an good LDO will bump up the noise floor, and a cheap lcsc part will do so too. Plus you’s want a reasonably low dropout and quiescent current, which also increases price. Maybe 10ct in volume is reasonable for such a part - and yes, that will absolutely eat the margin
That’s definitely true. But I would definitely pay more for a scale with ultra long battery life.
I made the mistake of buying an off brand digital calliper and now like an idiot I find myself removing the battery when it’s not in use just to avoid damn thing running flat in one month thanks to its atrocious standby current which enables the display to turn on instantly when I move the slide (rendering the on/off entirely moot).
Next time I’ll just bite the bullet and buy a Mitutoyo.
Same story here. You described it perfectly. Mitutoyo comes next.
I find spending a bit more on batteries goes along way. Although the nominal voltage and size may be the same, better batteries have lower internal resistance, ie provide the same current with less voltage sag. This prevent the low bat detection from tripping prematurely.
Lol I must have one similar. Burned through a battery in storage and when I replaced it, I noticed that the display is still active even when off - such a weird design. I pop the battery half out for storage every time now.
It’s a terrible design. If they removed that dumb always on feature and used a proper physical power button the battery would last basically forever.
The problem would be solved if these scales would take a AAA battery which has a lot more capacity than a tiny cell.
deleted by creator
Absolutely, My kitchen scale remains accurate and can use the same battery for years.
Eventually, the battery drops lower than the device needs. So no, none of which is fixed by a voltage regulator.
No, not voltage, current.
Which in this case means: you need a constant supply voltage