So what’s the leading theory on this guy? He was always horrible but we didn’t know? His brain turned to mush and Uber conservatism after the accident? Russia or whomever now have shit on him? He just turned super self interested and saw there’s more money in being a Trump lackey?

Wait, can you genuinely explain your comment? I mean in a meaningful nuanced way?

I want the unimaginable amount of harm Bimbo-Goebbeles is doing to be called out. She’s not just lying, she’s actively normalized institutional gaslighting, basically setting up the premise necessary for the public to have just enough doubt about the veracity of the horrific stuff they’ll hear about that it empowers the fascists to move on to more and more horrible deeds… Holy smokes this bunch is dangerous

So what’s the bigger picture “why” behind this? Why is it so very important to Uber conservatives that Israel be unchallenged as they shamelessly transition from legitimate fury to indefensible carnage?

“systemic human resources roadblock removal”

What plastic duct? It’s a standard foil one, but had a break in a couple of spots and since we’re replacing it by a new one next week, we have a piece of tape on it… Am i referring to the wrong thing?

UPDATE thanks all for the comments, just a few clarifications and updates:

• all electrical work is work-in-progress, we’re finishing it up tomorrow, it’s still an active worksite. The old outlet and old bx wiring is being removed, we’ll only have the newer wiring (and of course all outletd will be in their gangboxes and covers will be on)

• the dryer vent will be changed and installed without sag when we finalize

• the 4" abs drain connects to the old one with a rubber fernco gasket, those do require hose clamps and they’re up to code (though the top clamp could be straightened!)

• the water lines are pex, they’re all good

• we don’t have a choice but to push the water up with the washer pump - the drain evacuates to the city sewer around hip level in that basement

The worries for me are really the 90° out of the sump pump and the other 90° into the drain column, shouldn’t that be a downward Y? And the double S p-trap, is it creating some risk?

The top one, where the washer drain comes in? Or further down?

For the record he also connected the sump pump pipe like this, with a 90° - shouldn’t it be a downward Y instead?

This might actually be a good opportunity for an AI answer:

–

First, understand the basic principle you’re working with:

Shopping cart wheel locks respond to a specific RF (radio frequency) signal (typically around 7.8 kHz to 10 kHz for many systems, but it varies by brand).

In normal operation, the boundary wire emits this signal constantly.

The unlocking posts emit a different coded signal to reset the wheel.

So to design a portable device that could lock and unlock wheels manually anywhere, you would need:

1. Identify the Signals

You must figure out the exact frequencies and modulation patterns used by the cart system.

Different companies (like Gatekeeper Systems, Carttronics, etc.) use slightly different RF signatures.

Usually lock signal = basic broadcast (constant tone) Unlock signal = special modulated unlock code or sequence.

This might require:

A spectrum analyzer

Or reverse-engineering an existing unlock station.

2. Design the Portable Emitter

The portable device needs:

A programmable low-frequency RF transmitter (around 8–10 kHz range, low power)

A microcontroller (Arduino, ESP32, etc.) to generate the right modulation if the signal is coded

An amplifier to make the signal strong enough to reach the cart wheels (they usually detect it within 3–10 feet)

Optionally:

Two modes: a “lock” mode (sending the boundary signal) and an “unlock” mode (sending the unlock code).

3. Basic Hardware Components

Low-frequency oscillator (to generate 7.8–10 kHz wave)

Microcontroller (to handle switching, coding)

Coil antenna (for strong near-field transmission — like a small induction coil)

Amplifier circuit (boost the signal so carts sense it a few meters away)

Battery pack (portable, rechargeable — say 12V lithium-ion)

Mode selector switch (Lock / Unlock)

4. Software

Simple microcontroller code to:

Emit plain carrier signal = Lock mode

Emit modulated code = Unlock mode

Example (pseudo-Arduino code):

if (mode == LOCK) { generateContinuousTone(8kHz); } else if (mode == UNLOCK) { generateUnlockCode(); }

5. Important Challenges

Matching signal format exactly: If the unlock signal is digitally modulated (like FSK or ASK), you must match the timing perfectly.

Power levels: Too much power could fry circuits or interfere with nearby electronics. Keeping it safe is key.

Legal considerations: Broadcasting radio signals, even low-power ones, can be restricted depending on the country.

Simple Concept Sketch:

[Portable RF Cart Lock/Unlock Device]

Size: About a large walkie-talkie

Two buttons: Lock / Unlock

Coil antenna: About 3–6 inches

Range: 1–3 meters effective

Display: Small LED indicators (Locking / Unlocking / Signal OK)

In short: You’re essentially building a portable invisible “fence” generator with two channels: a “keep away” signal (lock) and a “come back” signal (unlock).

🤮

Right? I mean hindsight is 20/20 and all that, but come on…

Now it means technically you’d need some kind of shared enforcement accountability - but how to make any congress-controlled or judicial-controlled enforcement group big enough to compete with the US army when push comes to shove… 🤷‍♂️

All forces of enforcement of laws being created by one branch or interpreted by another being basically under the third, which incidentally is the one branch with an all powerful executive means the whole checks and balances was flawed from the get go, and assumed way too much good faith leadership, IMO

I would say come here to Canada, but… 🤷‍♂️

His job as the Fourth horseman of the apocalypse? 🤷‍♂️

Perfect part of the privatization plan. 1) make public stuff break 2) make private stuff there the competence is at

But it’s not even the same party?

Are you trolling (or actively propaganding?)

These are 2 different individuals from 2 different parties. Both center right by French standards, which makes them center left by US standards, but Claude Malhuret is absolutely not the same person as Edouard Philippe.

You know what, fair point. It wasn’t meant to encourage despair as much as vent my jadedness, and express my frustration at the fact that so many people still think this is just some shitty people in an otherwise democratic context…

But yes, super fair point. I hope you all find a way to uprise and fight this. You have a lot of friends up here.

I’m in Canada, and I can 100% guarantee we won’t capitulate, even if we’re outnumbered and outgunned 100:1 :)